About the magnetic drive pump lubrication, the magnetic pump before leaving the factory manufacturers will apply lubrication in advance on the bearing magnetic pump lubrication and other motor drive pump, the same is the use of the medium itself and lubricating grease to achieve lubrication, if insufficient lubrication, will lead to increased friction, resulting in early wear of related components, in the absence of dielectric lubrication, It will also cause abnormal pump temperature rise, which may lead to the risk of burning the pump. For details, please refer to the following content provided by saiken Pump industry. Grease, so bearing lubrication does not need the user to worry about, in the process of using the pump, mainly rely on medium transportation to complete the reduction of temperature and lubrication, so the magnetic pump is strictly prohibited idling, if once idling will cause the lack of media cooling and burn the pump. In addition, if the flow rate is lower than the standard value for a long time, the temperature of the pump chamber will also gradually rise, so it is recommended to keep the attention of the running condition when using the magnetic pump, once the flow problem occurs, stop processing in time.
Simply put, magnetic pump lubrication does not need the user to worry too much, only need to ensure that the transportation state is always stable, there will be no lubrication problems, and for the lubrication of the moving components in the pump, it is recommended to carry out a routine inspection every six months to a year, to check the wear of the internal bearing, if necessary to reapply grease, The specific maintenance cycle can be determined according to the working environment and pump frequency. In addition, in order to ensure constant flow in actual working conditions, it is recommended that customers do the following work in advance to prevent the occurrence of unexpected failures.
1. Properly install the magnetic pump, select the installation position according to the working environment and pump type parameters, and pay attention to the length and bending of the pipe layout do not exceed the standard;
2. Before opening the pump, pay attention to the number of cycles of the manual disc pump, confirm that there is no card and then start, and pay attention to the sufficient amount of medium at the pump entrance;
3, optimize the operation parameters, so that the parameters remain in the standard value, too low will cause abnormal temperature, too high will appear overload;
4. Install the filter device at the entrance of the pump, and introduce in advance that there are no foreign bodies exceeding the transport limit in the medium to be transported.
The above content is simple and explains the magnetic pump lubrication, overall, as long as the correct use of magnetic pump, do not need to worry about lubrication problems, it is recommended to arrange a special person to use the pump and in each use and maintenance after the corresponding records, so can effectively improve the stability of the water project, if you want to know more such as screw pump, multistage pump and other pump information, Sustainable focus on saiken pump industry.
