3 Inch Deep Well Pump

Max. Flow: 3.6m3/h
Max. Head: 142m
Application Limits
Max. ambient temperature< 40℃;
Sand content(in mass fraction)up to 0.01%;
Hydrogen sulfide content up to 1.5mg/L, chloride ion content up to 400mg/L;
pH 6.5 to 8.5;
Maximum: 70 m below the static water table.

Categories:Deep Well Pump

Add To Basket Get A Quote

Product Details

Description

Performance Range
Max. Flow: 3.6m3/h
Max. Head: 142m
Application Limits
Max. ambient temperature< 40℃;
Sand content(in mass fraction)up to 0.01%;
Hydrogen sulfide content up to 1.5mg/L, chloride ion content up to 400mg/L;
pH 6.5 to 8.5;
Maximum: 70 m below the static water table.

Installation and use
1. Agricultural irrigation
2. Drinking water, livestock water, village or household water supply
3. Garden and garden irrigation system
4. Desertification control

Features
1. The 3 Inch Deep Well Pump uses 100% copper wire and cold rolled silicon steel sheet.
2. It also has a natural rubber seal and a rubber stator to cast stainless steel components.
3. This pump uses a permanent magnet brushless DC motor. Compared with the traditional AC current machine, the efficiency is increased by 25%, and its wear level is low, which can extend the service life of the motor.
4. In the case of insufficient light such as cloudy weather, it can ensure the continuous operation of the pump body by reducing the current to adapt to the output power of the solar energy.
5. It can be installed in holes of 3 inches or larger.

Optional available on request
The discharge chamber and inlet components are made of brass or stainless steel 304.

Deep Well Pump

3 Inch Deep Well Pump

Products

Hot Products